EN - CA
  1. EN - US
  2. FR - CA

Added to your cart

Your cart is empty.
Show Cart Page
Complete Order
Sedna Smart water leak detector with perimeter cable – Zigbee

Technical specifications
Water leak detector with perimeter cable
WL4210C

Dimensions

Detector:

Height:
1.91 cm (0.75 in)
Width:
6.37 cm (2.5 in)
Depth:
6.37 cm (2.5 in)
water-leak-detector-with-perimeter-cable

Perimeter cable

Cable lenght:
2.2 m (7 ft)
Cable diameter:
5.9 mm (0.2 in)

Recommended
locations

The detectors with perimeter cable can be installed in the following locations.

Near the following appliances:

  • Water heater
  • Washing machine
  • Dishwasher
  • Piping
  • Drain pump
  • Refrigerator
  • Sink
  • Toilet
  • Water softener
  • Bathtub

Places with risk of frost:

  • Wine cellar
  • Piping
  • Unattended cottage or vacation home

*Indoor installation only.

Compatibility

The WL4210C* Smart Water Leak Detector can interact with the following devices:

2nd gen. Smart Water Valve
Wi-Fi
VA4220WF/VA4221WF

Sedna smart water valve by Sinopé
Wi-Fi Water Valve VA4220WF

2nd gen. Smart Water valve
Zigbee
VA4220ZB/VA4221ZB

Sedna smart water valve by Sinopé
Zigbee Water Valve VA4220ZB

GT130 gateway or Zigbee compatible system

GT130-gateway
GT130 Gateway Zigbee
Compatible
platforms

Compatible with:

Neviweb*
Hubitat

*Sinopé valve or GT130 gateway required

Functionalities

Neviweb

Hubitat

Communicate with the Sinopé Sedna Wi-Fi smart water valve to shut off the water supply as soon as a leak is detected.

Neviweb

–

Hubitat

–

Detector battery status

Neviweb

–

Hubitat

–

Indoor temperature

Neviweb

–

Hubitat

–

Features

The WL4210C Water Leak Detector has the following features:

  • Ultra-precise perimeter cable that detects water* in hard-to-reach areas
  • Possibility to fix the detector on the wall or the floor to prevent it from being moved by using the provided fasteners
  • Detects water leaks over its entire length (7′)
  • Possibility to put two perimeter cables end to end to double the protected area
  • Audible alarm indicating water leak detection or low batteries
  • Perimeter cable made of conductive polymer resistant to corrosion and abrasion
  • Battery-powered (included)
  • Possibility of dual detection based on positioning
*The cable also detects waste water, deionized water and a mixture of glycol and water.

Neviweb

  • Choose in which situation(s) you would like to receive alerts by email or push notification (detection of a leak, risk of frost, etc.)*
  Push notification Email alert
2nd gen. Wi-Fi Valve (VA4220WF) Yes Yes
2nd gen. Zigbee Valve (VA4220ZB) Yes Yes
  • Connect the detectors to the valve and rename them in the app to quickly identify the source of the leak
  • Link your water leak detector with the Sedna Wi-Fi smart water valve to close the water inlet as soon as a leak is detected. The detector can also be connected to the GT130 gateway to close the Sinopé Zigbee valve.**

  • See the battery status directly in the app

  • Create automations in the app so that the other Sinopé connected devices in your smart home react when water is detected***
*Requires a Sinopé smart valve or Zigbee-compatible system, a permanent Internet connection and the Neviweb app available on the App Store and Google Play.

**IMPORTANT: In case of power failure, the signal between the water leak detector and your gateway Zigbee will not be possible. The close signal won't be able to reach the valve. For optimum protection, even in the event of a power failure, the Sedna VA4220WF-K5 water damage protection system is preferred.

***Available only with Sinopé Zigbee devices (requires GT130 gateway).

Power supply

2 AAA lithium batteries (included)

The battery life of the detector depends on the type of batteries used and the device to which it is connected:

 

Device Battery type Battery life (normal use)
2nd generation Sedna valve (VA4220WF/VA4221WF) Lithium 10 years
  Alkaline 5 years
GT130 gateway or other Zigbee gateways Lithium

4 years
  Alkaline

2 years

Battery life is calculated based on optimal usage conditions and may vary slightly.

In case of a power outage the WL4210 can't communicate with the GT130 gateway in order to shut off the Zigbee water valve
In case of power failure, the signal between the water leak detection device and your gateway Zigbee will not be transmitted. The close signal won't be able to reach the valve. For optimum protection, even in the event of a power failure, the Sedna VA4220WF-K5 water damage protection system is preferred.

Connectivity
requirements

Requires:

  • Sinopé Smart Water Valve, GT130 gateway or compatible Zigbee gateway
  • Permanent Internet connection
  • Smartphone or tablet

Communication
protocol

Zigbee 3.0
Frequency: 2.4 GHz
Transmission power: +20 dBm
Receiver sensitivity: -108 dBm

Temperature ranges

Operating temperature
0 °C to 40 °C (32 °F to 104 °F)

Storage
-20 °C to 50 °C (-4 °F to 122 °F)

Reading frequency

Every 7 seconds

Certification

Detector
Compliant with IC transmitter module: 22394-ZBM1501/ FCC ID :2AK2T-ZBM1501

In the box

water-leak-detector-with-perimeter-cable
  • WL4210C Water Leak Detector with 7′ Perimeter Cable
  • 2 AAA lithium batteries
  • 2 mounting adhesives for the detector
  • 7 self-adhesive or screwable fasteners for the perimeter cable
  • Installation Guide – French version
  • Installation Guide – English version

Warranty

3-year limited warranty

Version

North American

Documentation

Quick start guide WL4210C

Product Fact Sheet WL4210C

Subscribe to our
newsletter now!

Sign up for our newsletter to make sure you don't miss anything! Be the first to receive information on our promotions and new products, get tips and much more.
Un instant

You can withdraw your consent at any time. Pour For more details,
see our Privacy Policy ou Contact Us.

Surf the
summer
wave!

Get 15% off
the smart electrical load controller.*

Enter the code

SPLASH15

Reduce your energy consumption by remotely controlling your pool’s filtration and water heater.

*Offer valid from July 19 to July 26, 2021, at 3:00 A.M. EST.

Get 15% off
the smart electrical load controller.*

Reduce your energy consumption by remotely controlling your pool’s filtration and water heater.

Enter the code

SPLASH15

*Offer valid from July 19 to July 26, 2021, at 3:00 A.M. EST.